Universal fit for almost all golf carts rear seats, EZ-GO/Club Car/Yamaha.If you mount hanging on the outer half of the bars (cup holder is outside the bar), Will NOT interfere the flip rear seat. (As picture 7th shows)Tips:The mounting bracket is suitable for 1 inch square pipe.
Upgrade set of 4 stainlesupport frame ( 2 PCS each side ), Not easy to tilt or broken. More durable.
About the support frame: Integrated construction and no extra screws required. Not easy to loosen over time. Easy installation and more strength than split type. ( As figure 3 shown )
Upgrade high strength crisscrorib design. ( As figure 2 shown ), More stronger torsion resistance. – Upgrade high density sponge design. ( As figure 5 shown ), More durable and more better support.
Easy installation – No drilling required, You can finished it within 10 minutes.
RoykUpgrade Golf Cart Armrest with Cup Holder – Universal fit for almost all golf carts rear seats, EZ-GO/Club Car/Yamaha.
Upgrade set of 4 stainlesupport frame ( 2 PCS each side ), Not easy to tilt or broken. More sturdy,stable and durable.
About the support frame: Integrated construction and no extra screws required. Not easy to loosen over time. Easy installation and more strength than split type.
Upgrade high strength crisscrorib design. More stronger torsion resistance.
Upgrade high density sponge design. More durable and more better support.
golf cart arm rest
Upgrade 1:
New Design “F” Type StainleSupport Frame
4 stainlesupport frame ( 2 PCS each side ), Not easy to tilt or broken. More sturdy,stable and durable.
About the support frame: Integrated construction and no extra screws required. Not easy to loosen over time.
No Drilling and Easy installation.
GOLF CART UPGRADE ARM RESTS
Upgrade 2:
Upgrade high strength criss-crorib design
High-impact plastic base with cricrorib design. More stronger torsion resistance.
Matched with the new design “F” type support frame, More sturdy and durable.
golf cart accessories
Upgrade ??:
Upgrade High Density Sponge Design
High density sponge provides better support and more durable.
Endurance test as the gallery picture 6 shown.
Easy to Install — 2 Steps
Step-1:
Step-2:
STEP-1:
Attached the brackets to the armrest using the Phillips head screws.
Warm tips: For those who own flip seats. you can mount hanging on the outer half of the bars. That will work perfect and allow your seat to flip.
STEP-2:
Position armrest on crossbar of rear seat as show. Hex Head Bolts through the 2 holes of bracket and use wrench to tighten.( Please remember put the flat washers and split-lock Washers )
CONTENS:
4 Brackets
4 Hex Head Bolts
4 Phillips Head Screws
4 Lock Nuts
4 Flat washers
4 Split-lock Washers
Tools Giveaway:
1 Phillips Screwdriver
2 Wrenches??one fixed and the other tighten)